Technical parameters:
Nominal pressure: 2.8MPa Applicable temperature:-50℃~+150℃
Test pressure: 4.2MPa Applicable medium:ammonia,fluorine,etc.
Characteristics:
- RACK are servo-operated valves normally closed and pneumaic open by
means of refrigerant gas of high pressure acting upon power piston,
taken from external high pressure line through the external joint,
AEVM-NC or NO fitted both on the valve bonnet.
- RACK valves are designed to work with ammonia and other common
fluorinated refrigerants,for use insuction lines of low temperature in
direct expansion or pump recirculation, defrost systems with hot gas
and any application that need a valve normally closed with automatic
opening for short time.
- RACK valves can operate with △p=0 and they must be installed in horizontal
position, with the pistonand pilot working in vertical direction.
- When the valve are closed.there is a bleed of gas through a small bore,
but only to close the valve when the hot gas stream is finished.
- The external joint of high pressure inlet, must be welded with the external
joint in size of 1/4" or 3/8".
Technical parameters:
Nominal pressure: 2.8MPa Applicable temperature:-50℃~+150℃
Test pressure: 4.2MPa Applicable medium:ammonia,fluorine,etc.
Characteristics:
- RACK are servo-operated valves normally closed and pneumaic open by
means of refrigerant gas of high pressure acting upon power piston,
taken from external high pressure line through the external joint,
AEVM-NC or NO fitted both on the valve bonnet.
- RACK valves are designed to work with ammonia and other common
fluorinated refrigerants,for use insuction lines of low temperature in
direct expansion or pump recirculation, defrost systems with hot gas
and any application that need a valve normally closed with automatic
opening for short time.
- RACK valves can operate with △p=0 and they must be installed in horizontal
position, with the pistonand pilot working in vertical direction.
- When the valve are closed.there is a bleed of gas through a small bore,
but only to close the valve when the hot gas stream is finished.
- The external joint of high pressure inlet, must be welded with the external
joint in size of 1/4" or 3/8".